Equipment Components and Power Supply
| Component No. | Component Name | Power Supply Parameters |
|---|
| 1 | Power | DC 12V (Direct Current 12 Volts); AC 100-240V, 50-60Hz (Alternating Current 100-240 Volts, 50-60 Hertz) |
| 2 | Dry Contact | Yes |
| 3 | Heat Sensor | Yes |
| 4 | Level Sensor | Yes |
| 5 | Ignitor | Yes |
| 6 | Combustion Tray | Yes |
| 7 | Screen | LCD Screen |
| 8 | Door | / |
| 9 | Leak Sensor Tube | / |
(2) Ignition Operation
The device can only be started/turned off using the On/Off Button on the device or the remote control. The remote control must be placed out of children's reach.
Press and hold the On/Off Button on the device for 3 seconds, or press the On/Off key on the remote control. The pump will automatically supply fuel to the fireplace; automatic ignition will occur after a few seconds. If the first ignition fails, the system will attempt ignition a second time. If ignition still fails, please check the "Error Message" on the LCD screen and refer to the "Error Messages and Function Prompts" section.
Never add fuel directly to the burner.
The device can only be turned off using the On/Off Button on the device or the remote control. After shutdown, the pump will stop working. Do not leave the room until the flame is completely extinguished.
For safety reasons, the device cannot be re-ignited immediately after shutdown. You must wait until the fireplace temperature drops below 60°C (140°F); it is recommended to wait a few minutes before attempting to start the device again.
Post time: 2025-09-08 09:09:31
